The Things Network

In order to use The Things Network (TTN) you should navigate to their website and create/register an account. Enter a username and an email address to verify with their platform.

Once an account has been registered, you can register your Pycom module as either a node or a nano-gateway. The steps below will detail how to do this.

Create an application

In order to register your device to connect to the things network, you must first create an application for these devices to belong to. This way the Network will know where to send the devices data to.

Selecting the Applications tab at the top of the TTN console, will bring up a screen for registering applications. Click register and a new page, similar to the one below, will open.

Enter a unique Application ID as well as a Description & Handler Registration.

Now the Pycom module nodes can be registered to send data up to the new Application.

Register a Device

To connect nodes to a things network gateway, devices need to be added to the application. To do this, navigate to the Devices tab on the Application home page and click the Register Device button.

In the Register Device panel, complete the forms for the Device ID and the Device EUI. The Device ID is user specified and is unique to the device in this application. The Device EUI should be a globally unique identifier for the device. You can run the following on you Pycom module to retrieve its EUI.

from network import LoRa
import ubinascii

lora = LoRa()
print("DevEUI: %s" % (ubinascii.hexlify(lora.mac()).decode('ascii')))

Once the device has been added, change the Activation Method between OTAA and ABP depending on user preference. This option can be found under the Settings tab.

Register a Nano-Gateway

You can also setup your Pycom module to act as a gateway with The Things Network. The code required to do this can be found here.

Inside the TTN Console, there are two options, Applications and Gateways. Select Gateways and then click on register Gateway. This will allow for the set up and registration of a new nano-gateway.

On the Register Gateway page, you will need to set the following settings:

These are unique to each gateway, location and country specific frequency. Please verify that correct settings are selected otherwise the gateway will not connect to TTN.

You need to tick the "I'm using the legacy packet forwarder" to enable the right settings. This is because the Nano-Gateway uses the 'de facto' standard Semtech UDP protocol.

Most LoRaWAN network servers expect a Gateway ID in the form of a unique 64-bit hexadecimal number (called a EUI-64). The recommended practice is to produce this ID from your board by expanding the WiFi MAC address (a 48-bit number, called MAC-48). You can obtain that by running this code prior to configuration:

 from network import WLAN
 import binascii
 wl = WLAN()
 binascii.hexlify(wl.mac())[:6] + 'FFFE' + binascii.hexlify(wl.mac())[6:]

Once these settings have been applied, click Register Gateway. A Gateway Overview page will appear, with the configuration settings showing. Next click on the Gateway Settings and configure the Router address to match that of the gateway (default: router.eu.thethings.network).

The Gateway should now be configured.